Test Setup

-) Can my material be applied in small quantities and repeatable?-) Can I dose it directly from the original container?-) Can my material be permanently exposed to compressed air or does it harden when exposed to air??-) How long can it be stored in cartridges or pressure tanks?-) Does it harden in the dispensing tips?-) Does it drip after dispensing? Does it pull strings? ... these are all questions that arise when using a new material. During a material test, we check the dispensing behaviour of your material with the appropriate dispensing technology. The costs depend on the customer requirements. The minimum cost is € 300,00. Your advantages after a material test: if the material can be dispensed with compressed air if the material can be dispensed directly from the original cartridge or must be transferred before if it has to be heated before dispensing how to prevent delay-yield or cob-webbing how long the material needs to cure on the workpiece how long it can be stored in the dispensing cartridge which "dispensing technology" is necessary for this (complete solution including all necessary fastening parts and brackets as well as tubing) which consumables will be used in the dispensing process you can calculate your costs in advance you know all settings regarding pressure, travel speed, tip diameter, cartridge size you can determine the cycle times and the productivity of the automated process   For a test setup we need: the material to be dispensed in the original cartridge (possibly in advance a technical data sheet) some workpiece samples description/sketch, where and how much material should be dispensed some general informations about the planned process: how many workpieces should be loaded per workday with the material? which cycle time should be reached? how much material will be needed per workpiece? is it already done by hand? Application in the industry: semiconductor PCB-components socketing and bonding LCD-bonding electrical components (such as relays, speakers, batteries) automotive clothing medicine optics used materials: fats silicones 2k-bondings solder pastes conductive adhesives uv-adhesives epoxy resins sealants other liquid materials  

In a dispensing setup with a robot, we set up your application in our laboratory and dispense your material on your workpiece samples. As part of the test setup, we optimize the process by using the most appropriate valves and also testing the correct settings for pressure, travel speed and tip diameter for your material. We will document the results for you via video and pictures. We will send the workpieces back to you so that you can finalize them. On request, you can also view the dispensing process personally and "live" during a visit to us. The minimum cost of a roboter testsetup is € 600,00. Our offer for you: When placing the order for the robot dispensing solution shown, 50% of the test setup costs will be credited* to the order amount!*) onetime valid for one tested material and one workpiece sample type   Your advantages after a test setup: You can be sure that your planned automated application is actually working Which "dispensing technology" is necessary for this (complete solution including all necessary fastening parts and brackets as well as tubing) Which consumables will be used in the process You can calculate your costs in advance You know all settings regarding pressure, travel speed, tip diameter, cartridge size You can determine the cycle times and the productivity of the automated process Upon request, we will create the final robot program for you (optional, upon agreement and expense, final workpiece holder compulsory)  For a test setup we need: The material to be dispensed in the original cartridge (possibly in advance a technical data sheet) Some workpiece samples Description/sketch, where and how much material should be dispensed Some general informations about the planned process: How many workpieces should be loaded per workday with the material? Which cycle time should be reached? How much material will be needed per workpiece? Is it already done by hand?   Application in the industry: semiconductor PCB-components socketing and bonding LCD-bonding electrical components (such as relays, speakers, batteries) automotive clothing medicine optics used materials: fats silicones 2k-bondings solder pastes conductive adhesives uv-adhesives epoxy resins sealants other liquid materials